If your system only supports a firmware-based TPM, it might be referred to as iPPT (Intel Platform Protection Technology) if your computer has an Intel processor, or fTPM (Firmware Trusted Platform Module) for AMD processors. Once here, you can also enable Secure Boot from the UEFI menus. IT can then request the TPM to provide a report on whether a system booted securely. The specific spot to enable TPM in these settings will vary wildly by manufacturer, so you should check the manual that came with your computer or motherboard (you can probably find it online on the manufacturer's website). TPM 2.0 can be used to measure each step of the Secure Boot process. It's usually accessible by pressing Delete or F12 when prompted during boot up. Once youve enabled TPM, find Secure Boot. When TPM 1.2 is installed, the TPM Security option is set to Off, On with Pre-boot Measurements, or On without Pre-boot Measurements. This is the low-level software you can briefly enter when your computer is first starting up. Once in BIOS, make sure it is in advanced mode, and then make sure that TPM is enabled. If it is compatible, you can enable it in your system’s UEFI (sometimes still referred to as a BIOS, even though this term is largely deprecated). It should be next to System Model.) If it's not compatible, there are ways to bypass the requirements, but it requires a bit of technical know-how and we don't recommend it. (You can find your model by tapping the Windows key and typing System Information. ![]() First, look online to see if your motherboard model is TPM compatible.
0 Comments
Leave a Reply. |